XY-510 Polymer Suspending Agent for Agrochemical Formulations

Application

XY-510 is documented for pesticide thickening, emulsification and suspension. The same source also lists fertilizer suspension and thickening, water treatment suspension, coatings, paper bonding and oilfield separation applications. Contact our technical team to confirm the grade for your specific active ingredient, dosage form, water quality and process.

Formulation Type

Aqueous pesticide and fertilizer suspensions; confirm suitability for the actual solids, water quality and process.

Key Benefits

The following functions are described in the published source; they are not measured results for every formulation.

The source describes thickening, suspension and emulsion stabilization through a weak gel-like network in water. Performance must be evaluated in the intended formulation.

Technical Data

See the technical specifications table above and the source TDS below. Keep the stated units, dosage basis and test conditions together when comparing grades.

Confirmed source specifications

The source TDS reports a pale yellow fine powder, 80 mesh particle size, maximum 15% loss on drying, viscosity above 1600 cP, an addition level of 0.05-0.3% and an optimum pH range of 5-10. The TDS does not state the viscosity test concentration, temperature, instrument or spindle speed, so the viscosity value should be used as a source specification pending test-method confirmation.

Addition level and processing

The source TDS lists 0.05-0.3%, but does not define the dosage basis. Confirm the numerator separately: mass of supplied XY-510 powder or mass of active material. Confirm the denominator: total formulation, water phase, dry solids or another explicitly defined mass. Do not treat these bases as interchangeable or use this range as a confirmed production recommendation.

For a trial recommendation, provide the formulation composition, solids content, water quality and process. Request the starting dose, dispersion and hydration procedure, temperature, mixing time and shear conditions in writing. For the viscosity value above 1600 cP, request the sample concentration and basis, preparation and hydration time, test temperature, instrument, spindle or geometry, speed or shear rate, and reading time.

Compatibility and formulation testing

The source describes solubility and stability under acidic and alkaline conditions, with an optimum pH range of 5-10, and compatibility with most metal salts. Confirm compatibility with your pesticide or fertilizer formulation, other additives and process conditions through application testing before scale-up. Record the test concentration, temperature, mixing conditions, storage time and evaluation method.

Storage and packaging

The source TDS lists 25 kg packaging and a two-year shelf life when stored dry at room temperature.

Application selection and trial guide

Download TDS

Download TDS – XY-510 (Chinese)

Both the original Chinese TDS and the English TDS on this page are available. Request a separate SDS and formulation-specific advice.

The linked XY-510 source document is a Chinese TDS. Contact our technical team for formulation advice, a separate SDS and a sample. Browse the thickening and rheology modifier range or visit technical downloads.

The linked document identifies its issuer, brand and model. A catalogue listing does not by itself establish the manufacturer or a brand authorization. Confirm the manufacturer and any applicable authorization for the exact grade when requesting a quotation. A TDS is not a substitute for a separate SDS.

Request Sample

State XY-510, the formulation type, intended application and target market. Request sample availability, supporting documents and a formulation-specific trial recommendation.

Request Sample – XY-510